Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Fast, Reliable Furnace Repair Across Murrieta
Furnace repair in Murrieta typically costs $150-$700 and most calls are completed same-day when you reach us by early afternoon. Our Furnace Repair team dispatches from our Inland Empire office and carries common blower motors, igniters, and control boards for the nine brands we service, including Rheem, York, and Bryant units that dominate Murrieta’s 1997-2008 housing stock. Call (817) 402-2972 and a live person picks up, 24 hours a day, even on holidays.
We’ve worked on enough furnaces in Greer Ranch, Copper Canyon, and the older tracts off Clinton Keith Road to know what breaks here and why. Murrieta’s builder-grade equipment is aging out on a concentrated schedule, and that changes how we approach every Murrieta AC Repair and service call.
Why Coldharbour Heating & Air Is Murrieta’s Preferred Furnace Repair Company
Coldharbour Heating & Air has been part of the Kingswell network since 2003, and our independently owned operation holds itself to standards most HVAC companies won’t put in writing. When you call us for Furnace Repair in Murrieta, you get The Kingswell Way: a written price before any work starts, a firm arrival window, a clean job site, a written 365-Day Done Right Promise, and a free return visit if the repair fails within that full year.
Our technicians are background-checked, uniformed, and trained on Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard systems. We don’t send a parts-chaser who has to call a supervisor. The tech who walks through your door in Murrieta has the training and the inventory to fix what you have.
Phones are answered by a live person around the clock, every day of the year. No voicemail trees. No “leave a message and we’ll call back tomorrow” when your furnace quits on a January night in the low 30s.
Heat Pump Repair in Murrieta
Heat Pump Repair in Murrieta covers systems that both heat and cool your home using refrigerant rather than burning gas, and these dual-mode units work especially hard here because Murrieta’s inland valley climate forces them to run year-round, summer highs above 100°F and winter nights in the 30s. A heat pump repair typically runs $150-$700, same as gas furnace repair, and our techs carry OEM and universal-fit components for Rheem, Daikin, and York heat pumps common in the area.
Reversing Valve and Defrost Control Issues
The reversing valve switches your heat pump between heating and cooling mode, and when it sticks or leaks refrigerant, you’ll get lukewarm air in winter or weak cooling in summer. We test superheat and subcooling to confirm the diagnosis before quoting replacement.
Compressor Electrical Failures
Heat pump compressors in Murrieta take more annual run hours than coastal units because both seasons demand them. Capacitor degradation and contactor pitting are early warning signs we catch before the compressor itself fails.
Heating Repair in Murrieta
Heating Repair in Murrieta means fixing any system that warms your home, whether it’s a gas furnace, heat pump, or hybrid dual-fuel setup, and the urgency is real when overnight temperatures drop into the low-to-mid 30s from December through February. A heating repair call in Murrieta costs $150-$700 depending on the component, and we issue a written price before touching a single tool.
Gas Furnace Heat Exchanger Evaluation
We combustion-test and visually inspect heat exchangers on every furnace repair call where combustion gases are involved. A cracked heat exchanger can leak carbon monoxide into your ductwork, and we won’t patch around that. If we find cracks, we give you a written report and a straight recommendation, repair or replace.
Attic Ductwork Static Pressure Testing
Murrieta’s original attic ductwork runs through spaces that hit 140-150°F in summer. That heat degrades flex duct seams and drives blower motors past their design load. We measure static pressure to see if your ducts are choking the system, not just swap the part that failed.
Trusted Brands We Service in Murrieta
We stock local parts and maintain supplier relationships for Rheem, York, Daikin, and Bryant systems, which means most furnace repairs in Murrieta don’t wait on a warehouse shipment from Los Angeles. Our trucks carry blower motors, igniters, flame sensors, gas valves, and control boards matched to the equipment installed in Murrieta’s 1997-2008 tract homes. When a Greer Ranch homeowner calls with a York furnace down on a Friday evening, we don’t tell them to wait until Monday for a part.
Common Furnace Repair Problems We See in Murrieta Homes
- Cracked heat exchangers on original builder-grade furnaces. Murrieta’s housing boom concentrated furnace installations between 1997 and 2008, so heat exchangers across the city are hitting metal-fatigue failure on the same timeline. We combustion-test to confirm cracks and give homeowners a written replacement recommendation when repair is no longer safe.
- Blower motor failure from attic heat exposure. Ductwork in unconditioned Murrieta attics bakes at 140-150°F every summer, cooking motor windings and bearings years ahead of manufacturer estimates. We replace the motor and check static pressure to see if duct restrictions are accelerating the damage.
- Ignition and control board faults from dust and thermal cycling. Santa Ana winds drive fine chaparral dust into furnace cabinets, coating igniters and flame sensors, while two decades of daily heat expansion and contraction fatigues solder joints on control boards. We clean what can be cleaned and replace what can’t.
- High-limit switch tripping from restricted airflow. Collapsed flex duct in hot attics, clogged filters from dust events, and failing blower motors all push furnace temperatures past safe limits. We don’t just reset the switch; we find what’s causing the overheat.
Pricing for Furnace Repair in Murrieta, CA
Most furnace repairs in Murrieta fall between $150 and $700, with simpler fixes like igniter or flame sensor replacement at the lower end and blower motor or heat exchanger work at the upper end. Here’s how our service pricing breaks down for Murrieta homeowners:
| Service | Typical Range in Murrieta |
|---|---|
| Furnace Repair | $150-$700 |
| AC Repair | $150-$650 |
| Tune-Up | $80-$200 |
What moves a repair toward the higher end? Blower motor replacement on a two-story 3,000 sq ft home with hard-to-access attic mounting. Heat exchanger replacement, which we often recommend against on 20-year-old equipment because the rest of the system is equally aged. After-hours emergency calls carry no overtime charge at Coldharbour, but the parts and labor rate is the same.
We hand you a written price before any work begins. That price does not change when the job is done. If we find additional issues during repair, we stop, explain, and get your approval on a new written price. No surprises at the door.
We Also Serve Cities Near Murrieta
Our Inland Empire crews serve Murrieta locally and also respond to calls in Wildomar, Lake Elsinore, Temecula, and Menifee. Dispatch and scheduling are coordinated from our Riverside-San Bernardino office, with technicians routed to minimize wait times across southwest Riverside County.
Serving Murrieta, CA - Our Local Coverage Area
We’re based in the Murrieta area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Murrieta
Replace, in most cases. A 2003 builder-grade furnace in Murrieta is now 20-plus years old, and when the heat exchanger or blower motor fails, the remaining components are on the same aging curve. We repair what makes sense, but we’ll give you a written replacement quote alongside any repair option so you can compare the 365-Day Done Right Promise on repair against the long-term value of a new system with a full factory warranty. Call (817) 402-2972 for an exact quote - estimates are free.
Short-cycling in cold weather usually means the furnace is overheating and hitting the high-limit switch, which shuts it down before the thermostat is satisfied. In Murrieta’s 1997-2008 homes, the culprit is often collapsed or leaking attic ductwork that restricts airflow, or a blower motor weakened by years of summer heat exposure in 140°F attics. We measure static pressure and inspect duct runs to find the root cause rather than just replacing the switch. Call (817) 402-2972 for an exact quote - estimates are free.
Murrieta’s inland valley location at 1,000-1,100 feet elevation, 30-plus miles from the coast, forces furnaces and heat pumps to work hard in both heating and cooling seasons, unlike coastal San Diego where heating loads are minimal. Santa Ana wind events from September through November drive chaparral dust directly into outdoor cabinets and through attic vents, coating igniters and control boards. Attic ductwork that bakes at 140-150°F every summer accelerates blower motor failure. These are Murrieta-specific wear patterns you won’t see in Oceanside or Carlsbad. Call (817) 402-2972 for an exact quote - estimates are free.
Yes. Our technicians repair both gas furnaces and heat pumps in Murrieta, including Rheem, Daikin, and York heat pumps common in newer tracts and retrofits. Heat pump repair runs the same $150-$700 range as furnace repair, and we carry reversing valves, defrost controls, and compressor electrical components on our trucks. Call (817) 402-2972 for an exact quote - estimates are free.
Most furnace repairs in Murrieta cost between $150 and $700, with igniter and flame sensor replacement toward the lower end and blower motor or heat exchanger work toward the upper end. We provide a written, itemized price before any work begins, and that price is guaranteed not to change. Every repair also comes with our written 365-Day Done Right Promise. Call (817) 402-2972 for an exact quote - estimates are free.
Written by Victor Mancini, Owner at Coldharbour Heating & Air, serving Murrieta since 2003.







Before
After
Before
After
Before
After