Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Snellville
Most furnace repairs in Snellville run $150-$700 and our technicians are usually at your door the same day you call. We dispatch from our Atlanta office and keep common parts stocked for the Carrier, Trane, Lennox, and Goodman systems found throughout Snellville’s neighborhoods. Call (817) 402-2972 and a live person will pick up, 24 hours a day.
We’re familiar with the specific headaches Snellville homeowners face: builder-grade furnaces from the 1990s and early 2000s, single-zone systems that can’t balance a two-story floor plan, and attic ductwork that’s been baking in Georgia summers for twenty-plus years. Our Furnace Repair team doesn’t just swap parts. We measure static pressure, check return sizing, and tell you whether your ductwork is part of the problem before we quote a repair.
Why Coldharbour Heating & Air Is Snellville’s Preferred Furnace Repair Company
We’ve been serving Gwinnett County since 2003 as an independently owned and operated member of the Kingswell network. That means every Snellville job is backed by four written promises: a price before the work starts, a firm arrival window, a clean job site, and our 365-Day Done Right Promise. If a repair fails within a full year, we come back and correct it at no charge. The guarantee is on paper before the technician leaves.
Our technicians are background-checked, uniformed, and trained on nine major residential HVAC brands. When you call (817) 402-2972, you reach a live person, not a voicemail tree, any hour of any day. Dispatching to Snellville is coordinated from our Atlanta office, and crews carry parts for the Trane, Lennox, Goodman, and Rheem systems that dominate local subdivisions.
Homeowners in Snellville’s 1990s-era neighborhoods call us because we’ve seen their exact setup before. The two-story with the thermostat downstairs and the master bedroom that never warms up. The attic duct run that’s undersized and leaky. The blower motor failing at year twelve because it’s been fighting excessive static pressure since installation. We don’t guess. We measure, show you the numbers, and fix what actually needs fixing.
Boiler Repair in Snellville
Boiler Repair in Snellville covers both hydronic hot-water systems and steam boilers, though gas furnaces outnumber boilers in local homes. When a boiler fails, you’re typically looking at no heat, uneven radiator temperatures, or a pressure relief valve that’s weeping water onto the basement floor. Most boiler repairs in Snellville fall in the same $150-$700 range as furnace work, depending on whether it’s a circulator pump, zone valve, or expansion tank replacement.
Diagnosing Circulator and Zone Valve Failures
A boiler that runs but doesn’t heat certain rooms usually points to a stuck zone valve or a dead circulator pump. We test each zone independently, check pump amp draw, and verify that your boiler’s aquastat is calling correctly. In Snellville’s older homes with original boiler installs, we often find zone valves that have been manually wedged open for years, masking a deeper control problem.
Pressure and Expansion Tank Issues
Boiler pressure that reads zero or spikes to 30 psi means the expansion tank has lost its air charge or the fill valve is stuck. We drain, test, and recharge the tank, then verify the pressure reducing valve is set to 12-15 psi for a typical two-story Snellville home. Running a boiler with failed expansion protection will trip the relief valve repeatedly and can crack the heat exchanger.
Gas Furnace Repair in Snellville
Gas Furnace Repair in Snellville is the bulk of our winter call volume, and nearly every call starts with the same housing stock: a 20-35 year old builder-grade unit in a two-story subdivision home with attic ductwork. The most common failures we see are cracked heat exchangers, failed ignitors, and blower motors that have been overworked by undersized returns. Repair costs run $150-$700 depending on the component.
Heat Exchanger and Combustion Safety
A cracked heat exchanger can leak carbon monoxide into your supply air. If we find cracks during inspection, we show you with a borescope camera and shut the unit down until it’s repaired or replaced. We got a call from a homeowner in the Dogwood Manor subdivision off Webb Gin House Road whose 2001 Carrier gas furnace was short-cycling every few minutes on the coldest mornings; the tech found a cracked heat exchanger and a blower motor dragging hard against a return static pressure well above spec in that attic ductwork. Once we pulled the static pressure readings and showed the homeowner the numbers, we replaced the blower motor and heat exchanger under the existing equipment and re-insulated the attic run, which stopped the short-cycling and dropped the gas use noticeably for the rest of the winter.
Ignitor, Flame Sensor, and Gas Valve Service
Modern furnaces use a hot-surface ignitor instead of a standing pilot. These ceramic elements crack after 3-5 years of thermal cycling. A failed ignitor means the furnace clicks but never lights. We carry replacements for Carrier, Trane, Lennox, and Goodman systems and can typically restore heat in a single visit. Gas valve failures are less common but more serious; we test inlet and manifold pressure with a digital manometer before declaring a valve bad.
Trusted Brands We Service in Snellville
Our technicians are trained to service Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. For Snellville homeowners, that means we stock common ignitors, blower motors, and control boards for the Trane, Lennox, and Goodman systems most frequently found in local 1990s subdivisions. We don’t order parts from a warehouse across the state and make you wait three days. Our Atlanta office maintains local inventory so most Snellville repairs finish same-day.
Common Furnace Repair Problems We See in Snellville Homes
- Cracked heat exchangers on 20-35 year old builder-grade furnaces. Snellville’s two-story subdivisions are filled with Carrier, Trane, and Lennox units installed during Gwinnett County’s boom. These heat exchangers fail from decades of thermal expansion, often caught only when a homeowner smells gas or the CO detector trips.
- Blower motors failing early from excessive static pressure. Attic-run ductwork in these homes is frequently undersized and leaky, pushing static pressure far above the furnace’s rated limit. The motor overheats and dies prematurely. We measure static pressure on every call and show you the reading.
- Short-cycling from single-zone thermostat placement. The thermostat sits downstairs while the upstairs master stays 7-10°F hotter, so the furnace never satisfies the call. It cycles on and off until the heat exchanger and ignition components wear out. This is a design problem, not just a parts problem.
- R-22 era furnaces paired with obsolete refrigerant systems. Many Snellville homes have furnaces from the 1990s tied to R-22 air conditioners that cannot be repaired to current environmental standards. We flag this early so you’re not surprised by a full system replacement recommendation.
Pricing for Furnace Repair in Snellville, GA
Honest pricing means you get the number before we touch a tool. Here’s what furnace and boiler work typically costs in Snellville:
| Service | Typical Range in Snellville |
|---|---|
| Furnace Repair (diagnostic, capacitor, igniter, blower motor, heat exchanger) | $150-$700 |
| Boiler Repair | $150-$700 |
| Tune-Up (furnace inspection, static pressure check, thermostat calibration) | $80-$200 |
What moves the needle within these ranges? The part itself is one factor, but access matters too. A blower motor in a tight attic closet takes longer than one in a spacious basement. Heat exchanger replacement is labor-intensive and sometimes makes more sense applied toward a new unit. We give you a written price for each option and let you decide. Estimates are free. Call (817) 402-2972 to schedule.
We Also Serve Cities Near Snellville
Our crews work throughout Gwinnett and Rockdale counties, including Snellville and the surrounding communities of Lilburn, Grayson, Conyers, and Redan. Same written guarantees, same live-answer phones, same upfront pricing.
Serving Snellville, GA - Our Local Coverage Area
We’re based in the Snellville area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Snellville
It’s usually a zoning and ductwork problem more than a furnace problem. Your builder installed a single-zone system with one thermostat downstairs, and the attic duct run to the upstairs is likely undersized or leaky. We measure static pressure and airflow at each register to determine whether a zoning retrofit, duct sealing, or equipment resize is the right fix. Call (817) 402-2972 for a free assessment.
Most furnace repairs in Snellville run $150-$700, with simple fixes like ignitor or capacitor replacement at the lower end and heat exchanger or blower motor work at the higher end. We hand you a written price before starting any work. Call (817) 402-2972 for an exact quote - estimates are free.
Short-cycling in Snellville’s 1990s-2000s homes typically stems from a single-zone thermostat that can’t satisfy the call because upstairs stays too hot, plus attic ductwork that’s leaking or undersized. The furnace runs, overheats, shuts off on high limit, and repeats until components fail. We check static pressure and temperature splits to find the root cause rather than just replacing parts that will fail again.
Yes, we repair the furnace itself, but we also check whether your indoor coil and outdoor unit still use R-22 refrigerant. If the cooling side is R-22-obsolete, a furnace repair may not make financial sense when the full system needs replacement soon. We give you both scenarios in writing so you can decide.
Boilers can absolutely be repaired, and many Snellville homes with hydronic heat keep them running for decades with proper maintenance. Circulator pumps, zone valves, and expansion tanks are all replaceable components. If your boiler is over 25 years old and the heat exchanger is cracked, we’ll quote both repair and replacement options with written prices for each. Call (817) 402-2972 to schedule a diagnostic.
Written by Victor Mancini, Owner at Coldharbour Heating & Air, serving Snellville since 2003.