Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across Selma
Most homeowners in Selma who call us for a new air conditioner need it installed before the next heat wave, and that timeline is realistic. We’re dispatching crews from our San Antonio scheduling office into Selma daily, and we can typically get a technician to your door within 24 to 48 hours for a free in-home estimate. Call (817) 402-2972 and you’ll reach a live person, not a voicemail tree, any hour of any day.
We’ve been working in the San Joaquin Valley long enough to know that AC Installation in Selma isn’t the same job it is in Fresno or Visalia. The houses here were built for agricultural families between the 1950s and early 1990s, and many still run on original flex duct, single-zone layouts, and electrical panels that weren’t designed for modern HVAC loads. A new condenser sitting on a pad out back won’t fix anything if the ductwork behind the walls can’t move the air.
Why Coldharbour Heating & Air Is Selma’s Preferred AC Installation Company
Our AC Installation team has replaced systems on Floral Avenue, near the Live Oak Park area, and throughout the older neighborhoods south of Whitson Street where the raisin yards sit closest to residential blocks. Victor Mancini and our crew know which Selma homes were built with slab-on-grade construction and inadequate attic insulation, and we know how to size a system that actually performs in those conditions.
Homeowners here tell us the same story: the last company swapped the outdoor unit, handed them a bill, and the master bedroom still wouldn’t cool below 78°F by 4 p.m. We don’t do swap-outs. We run a Manual J load calculation on every install, inspect the existing ductwork for static pressure and leakage, and check whether your electrical panel can handle the inrush current of a modern heat pump. Then we give you a written price before any work starts. That price doesn’t change at the door.
Every installation we complete is backed by the 365-Day Done Right Promise. If anything we install fails within a full year, we come back and correct it at no charge. The guarantee is written down before our technician leaves your driveway, not promised over a handshake.
Heat Pump Installation in Selma
Heat Pump Installation in Selma has become a practical choice for homeowners who want both cooling through the valley’s brutal summers and efficient heating through the Tule fog season. A heat pump moves heat rather than generating it, which means it can cool your home in August when the thermometer hits 105°F and warm it in January when fog keeps nighttime temperatures near freezing for weeks. Most Selma homeowners should expect to invest $3,500-$7,500 for a complete heat pump installation, including the outdoor condenser, matched indoor coil, and necessary electrical connections.
When a Heat Pump Makes Sense Over Straight Cool
If your home currently relies on a gas furnace for winter heat and an aging AC for summer, a Furnace Repair - Selma specialist can show you how a heat pump replaces both in a single system. This matters in Selma because many older homes have furnaces tucked into closets or attics with venting that doesn’t meet current codes. A heat pump eliminates combustion venting entirely. We see this configuration work especially well on the long ranch-style homes common east of Highway 99, where a single outdoor unit can serve the whole house if the ductwork is properly sealed.
Electrical Readiness for Heat Pump Conversion
Not every Selma panel can carry a heat pump. The inrush current on startup can trip breakers in 1970s-era 100-amp services, particularly if the home also runs a well pump or electric dryer. We check your panel during the estimate visit. If it needs upgrading, we tell you then, not after we’ve torn out your old system. This is part of The Kingswell Way: say the price before the work starts, and don’t leave a homeowner without heat or cooling overnight because of a surprise electrical issue.
Ductless Mini Split Installation in Selma
Ductless Mini Split Installation in Selma solves the problem that central air often can’t: cooling specific rooms in homes with no ductwork or with ductwork too damaged to salvage. A mini split pairs a compact outdoor compressor with one or more wall-mounted indoor units, each controlled independently. For Selma’s older homes with original slab-on-grade construction and no attic space for new ducts, this is frequently the most cost-effective path to refrigerated air. Expect $3,500-$7,500 for a quality single-zone system installed to manufacturer specification.
Room-by-Room Control for Problem Floor Plans
The split-level and long-ranch homes built across Selma in the 1960s and 1970s were designed with a single thermostat in the hallway. Bedrooms at the far end of the house routinely run 8-10°F off the setpoint. A ductless mini split puts a dedicated blower in that hot bedroom, controlled by its own thermostat. We’ve installed these on homes off McCall Avenue where the afternoon sun pounds the west-facing back rooms and the original duct system simply can’t balance the load.
No Ductwork, No Dust Loading
Here’s something we don’t talk about enough: Selma’s August and September raisin harvest fills conventional duct systems with agricultural particulate that standard filters can’t fully capture. A ductless system has no ducts to collect dust. The multi-stage filtration built into the indoor unit handles what enters the room directly. For homes closest to the active drying yards, this can mean fewer service calls and less strain on the equipment.
Trusted Brands We Service in Selma
Our technicians train continuously on nine major residential HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. In Selma, we most commonly install Rheem and York systems for their reliability in high-heat, high-particulate conditions, and we stock Bryant and Daikin parts locally for faster turnaround when a warranty issue arises. We don’t push one brand over another. We match the equipment to your home’s load calculation, your panel capacity, and your budget, then we put the guarantee in writing.
Common AC Installation Problems We See in Selma Homes
- Undersized flex duct from the 1970s: The original orange or gray flex duct in Selma’s older homes was sized for smaller tonnage units and can’t move enough CFM for modern equipment. Static pressure climbs, the evaporator coil freezes, and the compressor short-cycles itself to death by the second August heat wave.
- Electrical panels that can’t handle heat pump inrush: We see this on homes near the original Selma city grid, where 100-amp Federal Pacific or Zinsco panels still serve the house. A modern heat pump can draw 40 amps on startup. The breaker trips, the homeowner calls for service, and the real problem was never the HVAC equipment.
- Single-zone thermostats in split-level floor plans: The upstairs runs 85°F while the downstairs hits 72°F. Replacing the outdoor unit without addressing zoning or duct balance just gives you a new compressor that runs constantly and never satisfies either floor.
- Condenser coils clogged with vineyard dust: From mid-August through September, technicians servicing homes on the south and east edges of Selma routinely pull filters that are completely loaded with fine vineyard dust within three to four weeks of installation. The coil follows, head pressure spikes, and the system shuts down on high-pressure lockout.
Pricing for AC Installation in Selma, TX
We don’t do vague estimates. Here’s what Selma homeowners typically invest for a complete, code-compliant installation:
| System Type | Typical Range in Selma |
|---|---|
| Standard Split System AC Installation | $3,500 - $7,500 |
| Heat Pump Installation | $3,500 - $7,500 |
| Ductless Mini Split Installation (single zone) | $3,500 - $7,500 |
What moves you within that range? The size of your home and the result of our load calculation. Whether your ductwork can be sealed or must be replaced. Whether your electrical panel needs upgrading before the new system goes in. Whether we’re installing a single-zone mini split or a fully ducted central system with multiple returns. We give you a written, fixed price after our in-home assessment. No change orders at the door. No “we found something else” surprises. Call (817) 402-2972 to schedule your free estimate.
We Also Serve Cities Near Selma
Our crews work throughout the San Joaquin Valley and across Texas, including Selma and surrounding communities. We also provide full HVAC service to Houston, San Antonio, Dallas, and Fort Worth with the same written pricing, firm arrival windows, and 365-Day Done Right Promise.
Serving Selma, TX - Our Local Coverage Area
We’re based in the Selma area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in Selma
A load calculation measures exactly how much cooling your specific home needs based on square footage, insulation, window exposure, and duct condition. In Selma’s 1950s-1990s housing stock, we’ve found that original flex duct leaks 20-30% of its air before it reaches the rooms, and sun exposure on west-facing slab-on-grade homes drives heat gain well above what a simple square-footage guess would predict. Skip the load calculation and you get a system that’s either too small to hold temperature or too large to dehumidify properly. Call (817) 402-2972 and we’ll run the calculation during your free estimate.
Yes, and this check is non-negotiable on our installs. The compressor in a modern heat pump draws significant inrush current on startup, and many Selma homes still run on original 100-amp panels that can’t support the load alongside existing appliances. We check your panel during the estimate. If it needs upgrading, we tell you then and include that scope in your written price. We won’t leave you with a new system that trips the breaker every afternoon. Call (817) 402-2972 to schedule.
Selma sits at the center of California’s raisin belt, and the open-air grape drying operations that run from mid-August through September generate extraordinary particulate loads. Homes on the south and east sides of town, closest to the drying yards, see filters completely loaded with fine vineyard dust in three to four weeks. This isn’t a filter quality problem. It’s a local environmental condition that requires more frequent filter changes and, ideally, a condenser coil cleaning before the peak hits. We can set you up on a maintenance schedule that matches Selma’s harvest calendar. Call (817) 402-2972 to discuss.
Not if it’s a like-for-like swap. The problem is usually static pressure and duct design, not the age of the outdoor unit. Selma’s long ranch and split-level homes were built with single-zone ductwork that can’t balance airflow to far bedrooms. We address this by measuring static pressure, sealing leaks at the plenum and trunk connections, and sometimes adding a second return or recommending a ductless mini split for the problem zone. The new AC helps only if the duct system can actually deliver the air. Call (817) 402-2972 and we’ll show you exactly what’s happening in your ducts.
SEER2 is the updated testing standard that went into effect in 2023, and it measures efficiency under more realistic conditions including higher external static pressure. The number on the label will be lower than the old SEER rating for the same equipment, but the actual performance hasn’t changed. In Selma, where dusty coils and undersized ductwork are common, SEER2’s tougher test conditions matter because they better reflect what your system will actually deliver in your home. We explain the ratings on every proposal and help you choose equipment that qualifies for available rebates. Call (817) 402-2972 for current details.
Ready to get your home cooled right? Call Coldharbour Heating & Air at (817) 402-2972 for a free, written estimate on AC installation in Selma. We’ll show up in the window we promise, leave the job site clean, and put our 365-Day Done Right Promise in writing before we leave.
Written by Victor Mancini, Owner at Coldharbour Heating & Air, serving Selma since 2003.