Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Nevada
Most furnace repairs in Nevada, TX cost between $150 and $700 and are completed in a single visit by a technician who understands propane-fired systems and the ductwork quirks of older Collin County ranch homes. Coldharbour Heating & Air dispatches crews to Nevada from our Dallas-Fort Worth office, and we keep common ignitors, blower motors, and heat exchanger parts stocked for the propane furnaces and heat pumps that dominate this market. Call (817) 402-2972 anytime - a live person answers, even at 2 a.m. on a Sunday when your heat quits.
We’ve worked on enough Nevada properties to know the pattern: a furnace that “works fine” in mild weather starts throwing fault codes the first night the temperature drops below 25 degrees. The house sits on Collin County’s black clay soil, which holds heat against the slab through October but can’t protect ductwork routed through unconditioned vented attics. When that attic hits 40 degrees and the propane regulator is already marginal, the system fails. That’s when you need someone who shows up in the window promised, hands you a written price before touching a tool, and fixes the actual problem - not just the symptom.
Why Coldharbour Heating & Air Is Nevada’s Preferred Furnace Repair Company
We’ve been serving Collin County since 2003 as an independently owned and operated member of the Kingswell network, and Nevada has been part of our route long enough that our technicians recognize the split between pre-1980s rural properties and the newer suburban tracts that arrived with the McKinney growth wave. We don’t send a kid with a clipboard; we send a uniformed, background-checked technician trained on Carrier, Trane, Lennox, Goodman, and Rheem systems who knows how to read a propane furnace fault code.
Our 365-Day Done Right Promise is written on every repair, not offered as a verbal afterthought. If the ignitor we replace fails in eleven months, we come back and make it right at no charge. The price you sign before we start is the price on the final invoice - that’s The Kingswell Way, and it applies on every job, not just the easy ones.
Phones are answered by a live person 24 hours a day, 7 days a week. No voicemail trees. No “call back during business hours” when your heat pump is locked out on a 19-degree night.
Heating Repair in Nevada
Heating Repair in Nevada means diagnosing propane-fired furnaces, all-electric heat pumps, and the occasional boiler in a housing stock split between aging rural ranch homes and newer suburban builds. Most calls we run here are not natural-gas manifold checks; they’re propane regulator issues, thermocouple failures on standing-pilot systems, or heat pump changeover faults during severe cold snaps. The typical repair runs $150-$700, with most single-component fixes like ignitor or capacitor replacement landing in the lower half of that range.
Propane Furnace Diagnosis
When we pull up to a Nevada property without a natural gas meter, our technician starts with the propane tank percentage, regulator output pressure, and the thermocouple or flame sensor condition. These systems fail differently than natural gas units - the orifice sizing, gas valve spring rates, and combustion air requirements all vary. We’ve replaced enough propane valves on 1990s Lennox and Goodman units in Nevada to keep the common parts on our trucks.
Heat Pump Cold-Weather Failures
All-electric heat pumps in Nevada were often sized for North Texas’s typical mild winters, not the severe events that hit Collin County in February 2021. When the auxiliary strip heat is undersized or disabled, the system locks out and the house drops fast. We test actual amp draw on each heat stage and compare it to the load calculation the original installer should have run.
Boiler Repair in Nevada
Boiler Repair in Nevada is less common than furnace or heat pump work, but the rural properties east of FM 1377 and along the Collin County line still run hydronic systems - especially in homes built before central forced-air was retrofitted. A typical boiler repair here runs $150-$700, with circulating pump replacements and zone valve repairs at the lower end, and heat exchanger work or control board replacement toward the higher end. The same 365-Day Done Right Promise applies.
Propane Boiler Combustion Issues
Nevada’s propane boilers develop soot and combustion chamber deposits faster than natural gas units, especially when the air shutter or orifice is even slightly out of spec. We combustion-test every propane boiler we service and clean the burner assembly as standard practice, not an upsell.
Retrofit Zone Control Problems
Older Nevada homes that added hydronic zones during a remodel often have mismatched pumps and zone valves that chatter or fail to open fully. We map the actual flow against the original design and replace components with correctly sized equivalents - not whatever the supply house had closest on the shelf.
Trusted Brands We Service in Nevada
Our technicians train on nine major residential HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. For Nevada customers, we stock ignitors, blower motors, and control boards for the propane-fired Lennox and Goodman units we see most often in the older ranch homes, plus heat pump defrost boards and reversing valves for the Trane and Rheem systems common in the 2000s-era subdivisions. That local parts inventory means most repairs finish same-day rather than waiting on a Dallas warehouse pull.
Common Furnace Repair Problems We See in Nevada Homes
- Propane ignition failure on rural properties without natural gas service. The thermocouple generates weak millivoltage, the pilot won’t stay lit, and the homeowner smells gas near the regulator. We test propane pressure at the manifold and replace the failed component - not the whole valve assembly unless it’s actually bad.
- Heat pump lockout during severe cold snaps. The defrost board fails to terminate properly, ice builds on the outdoor coil, and the system shuts down on high pressure. Nevada’s all-electric homes need correctly sized auxiliary heat; we verify amp draw and check the sequencers.
- Short-cycling from crushed flex duct in vented attics. On pre-1980s Nevada ranch homes, original flexible duct was routed around framing added decades later, kinking the run and spiking static pressure. The furnace hits its high-limit switch and shuts off prematurely. Sealing and rerouting fixes it; swapping the furnace does not.
- Undersized electrical panels blocking modern system upgrades. Many older Nevada homes still run 100-amp services that can’t handle a heat pump’s compressor and auxiliary heat simultaneously. We flag this during repair calls so the homeowner knows before requesting a replacement quote.
Pricing for Furnace Repair in Nevada, TX
We don’t quote over the phone and then change the number at the door. Our technician diagnoses the system, writes the exact repair and price on a form, and hands it to you before any work begins. Most furnace repairs in Nevada fall between $150 and $700. A standard ignitor or flame sensor replacement typically runs $150-$280. Blower motor replacement lands around $350-$550. Heat exchanger repair or full control board replacement pushes toward the upper end. The $80-$200 heating-season tune-up catches most of these failures before they leave you cold.
What moves the price: accessibility (attic-mounted units in Nevada’s older homes take longer), whether the system is propane or electric (propane requires combustion testing we perform as standard), and whether the real problem is the furnace or the ductwork feeding it. We separate those issues clearly so you know what you’re paying for. Estimates are free. Call (817) 402-2972.
| Service | Price Range |
|---|---|
| Furnace Repair (diagnostic and repair labor) | $150-$700 |
| Tune-Up (heating-season inspection and cleaning) | $80-$200 |
We Also Serve Cities Near Nevada
Our crews run regular routes through Nevada and the surrounding Collin County communities - Lavon, Royse City, Fate, and Princeton. Dispatch and scheduling are coordinated from our Dallas-Fort Worth office, with local technicians carrying the propane and heat-pump parts inventory these markets need. Whether you’re on a ranch east of FM 1377 or in a newer tract near the city limits, our Furnace Repair team covers your area with the same written price guarantee and 365-day repair warranty.
Serving Nevada, TX - Our Local Coverage Area
We’re based in the Nevada area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Nevada
Yes - we repair propane-fired furnaces regularly in Nevada, where natural gas infrastructure stops at the Collin County frontier and most rural properties rely on propane tanks. Our technicians carry propane-rated ignitors, thermocouples, and gas valves, and we combustion-test every propane repair before we leave. Call (817) 402-2972 for a free estimate.
The problem is usually ductwork, not the furnace itself. Pre-1980s Nevada homes often had flexible duct crushed under later-added framing or routed through unvented attics with minimal insulation. We measure static pressure and airflow room-by-room; if the duct is kinked or undersized, sealing and rerouting fixes the temperature imbalance. A new furnace won’t.
Yes, we repair propane and electric boilers in Nevada’s older rural properties, especially east of FM 1377 where hydronic systems still heat homes built before forced-air retrofits. Most boiler repairs run $150-$700, covered by our 365-Day Done Right Promise. Call (817) 402-2972 to schedule.
No - a properly sized heat pump with adequate auxiliary heat should maintain temperature through Collin County cold snaps. Many Nevada systems were sized for mild winters and lack sufficient strip heat capacity. We test actual heat output against the load your home requires and correct the sizing or staging if it’s inadequate.
Most furnace repairs in Nevada cost between $150 and $700, with single-component fixes like ignitors or capacitors at the lower end and heat exchanger or control board work toward the higher end. We hand you a written price before any work begins, and that price does not change. Call (817) 402-2972 for an exact quote - estimates are free.
Written by Victor Mancini, Owner at Coldharbour Heating & Air, serving Nevada and Collin County since 2003.